PANTA HT 점퍼는 150 ° C의 기어 및 자동차 분야에서 영구적으로 사용하기에 적합합니다.

CHARACTERISTICS

  • Cost-effective alternative to Flex-rigid or Flex PCB
  • Connection of electronic components
    – board to board
    – board to sensors
  • Temperature range: -40 ° C to + 150 ° C
  • Insulation material: polyimide
  • Length range: 25 – 200mm
  • Wire diameter: 0.32 – 0.51mm
  • Grid: A = 2.54mm, B = 1.27mm, D = 2.00mm
  • Pole number: up to 32 pin

ADVANTAGES

  • 평평한 곳에서 둥근 곳으로 흐르는 흐름과 노치없는 전환
  • 평평한 선에서 원형선으로 전환됨으로써 고유진동의 보상
  • 납땜영역의 전압감소
  • 공진 방지효과

PASSED ANALYSIS TESTS

Lifetime tests
  • Temperature storage (1000h @ 170 ° C)
  • Pressure cooker test (96h @ 140 ° C)
  • Moisture test (pre-aging + 14 days @ 32 ° C & 85% RH)
  • Thermal shock storage (1000 cycles -40 ° C – 150 ° C)
UL758
  • Heat Shock Test @ 180 ° C
  • Dielectric test with aged samples (7 days @ 180 ° C)
  • solder bath
  • Cold bending test (4h @ -10 ° C)
  • Bend test after 7 days @ 180 ° C

ORDERING

CONNECTION FORMS

TECHNICAL SPECIFICATIONS

How to order B D A
Grid (mm) 1.27 2.0 2.54
Pole number max. 32 32 32
Length (mm) 30 – 200 30 – 200 30 – 200
Edge insulation min. (Mm) 0.8 0.8 0.8
Pin diameter (mm) 0.32 0.4 0.51
Wire size (AWG) 28 26 24
Flat conductor width (mm) 0.75 1.35 1.27
Flat conductor thickness (μm) 100 110 110
Conductor material Copper Cu-ETP (E-Cu);
tinned
Copper Cu-ETP (E-Cu);
tinned
Copper Cu-ETP (E-Cu);
tinned
Current carrying capacity at 20 ° C (A) 1.5 2.0 3.5
Rated voltage VDC 200 200 300
Dielectric strength (V DC / min ) 700 1500 1500
isolation polyimide polyimide polyimide
Operating temperature (° C) -40 … +150 -40 … +150 -40 … +150
Soldering temperature (° C / sec.) 260/5 260/5 260/5

Other versions on request.

PANTA HT Jumper (PDF, 247 kB)